Products Center
Reserving camera kit
Product Features
Product: Camera and display system for reversing car
Part No.: RM025A
【Application】
The system is applicable to all types vehicles. The camera should be installed at proper position of the vehicle and used with monitor.
Car Imaging Products Provide you with the best service.
【Features】
2.5‘ TFT LCD display.
Input Format: NTSC/PAL
CMOS camera.
Wireless picture transfer (optional)
With the line of distance (optional)
【Specification】
1,Display screen
2.5‘ TFT LCD
Input Format:NTSC/PAL
Display ratio: 4:3
Resolution: 882 × 228 Pixel Pitch: 0.056 × 0.168 (mm)
Average brightness:: 250 cd/m2 5. Contrast: 200:1 Response time: 25 ms
Audio output: ≥ 100mW Input voltage: DC 12V Power consumption: ≤ 4.5W
Signal Input: AV Input (with amplifier)
Operating temperature: 10 ~ 40 degrees
The appearance of: 82 × 60 × 32 (mm)
Weight: 105g
Packaging: carton
2,Camera
Lens Angle：135°/ 170°
Spec.：Φ23mm*33.85mm
Sensor：OV7950 or PC3010
Photosensitive components 1/4-inch color, CMOS
Tv System：NTSC
Resolution：480 Tv Lines
Effective Pixels：512*582 pixels
Minimum illumination：0.1-0.5 lux
Ip Rating：IP67/IP68
Video Output: 1.0vp-p, 75Ohm
The illumination 3LUX (infrared light at 0 Lux)
Lens 2.8mm,
Standard PAL / NTSC,
RCA video output interfaces,
Waterproof
0-5 meters night vision distance,
Mirror picture (optional)
With the line of distance
Net Weight：0.048kg
Display-Box: 0.045kg-28cm*12cm*3.5cm
Carton-Box (20pcs): 0.36kg-420*280*160mm
AV Lines：0.06kg
DC Lines：0.019kg
Brochure：0.003kg
Screw：0.005kg
3,Wireless A/V module(optional)
2.4G Wide Band reveice
low power consumption：3.3V 110MA
High reception Sensitivity ：-90 DBM
Built-in frequency, the PLL high stability
Direct output video signal
Gross weight：154g
【Installation】
1) Clean up the car trunk to sure the rang of operation don’t have any sundries;
2) Conform under the center of the car surround, and drill a hole with hole saw.
3) Put the camera into the hole, make sure upward icon on the shell of camera must be upwards;
4) Connect the positive and negative line of the wireless AV transmitter to the reversing power line, researching the suitable place and tear the surface of 3M HTG, fasten the wireless AV transmitter.
5) Connect the camera to the wireless AV transmitter;
6) Turn the main machine, and check if it works ok.
7) After check, To resume the trunk.
